Installing The Server Into The Pedestal Kit; Required Tools; Removing The Rails From The Server - HP Integrity rx2660 Installation Manual

2 Installing the Server into the Pedestal Kit

Use this chapter to install your rx2660 to a pedestal kit.
The following are the high-level procedures needed to install the rx2660 server into a pedestal
kit.
1. Remove the rack-mount rails from the server (if necessary).
2. Install the pedestal kit top and bottom pieces.
3. Install the bezel cover.
4. Install the pedestal kit left side piece.
5. Install the pedestal kit right side piece.
6. Install the pedestal kit feet.

Required Tools

There are no tools required for installing the pedestal kit, but a flat head screwdriver is required
to remove the pedestal kit from the server.

Removing the Rails from the Server

If your server has rails when you receive it, you need to remove the rails before mounting it in
the pedestal kit. Remove the rails from the server by doing the following:
1. Slightly pull the rail lock away from the rail to unlock the rail. See
2. Slide the rail toward the front of the server to disengage the rail from the posts on the server.
3. Repeat these steps for the rail on the other side of the server.
Figure 2-1 Removing the Rails from the Server
8 Installing the Server into the Pedestal Kit
Figure 2-1 (page 8).