7.
Disconnect the Systems Insight Display cable.
8.
Remove the Systems Insight Display module.
To replace the component, reverse the removal procedure.
If installing a replacement SID module:
1.
Retain the retain the SID bezel, the transparent light pipe, and the black rubber light pipe.
2.
Install the transparent plastic light pipe onto the SID bezel.
3.
Install the SID bezel onto the metal chassis, ensuring the four latches all lock.
4.
Put the black rubber light pipe onto the plastic light pipe.
5.
Install the SID board by securing it with the two screws.
6.
Fasten the two hexagon screws on the front of SID bezel to the VGA port.
7.
Install the component as described above.
Intrusion switch cable
The intrusion switch screws face CPU 0.
To remove the component:
1.
power off the server
2.
Remove the access panel
3.
Remove the PCI riser cage
4.
Open the CPU cage.
5.
Using a screwdriver Remove the switch.
6.
Unplug the mating connector
System board
To remove the component:
1.
Power off the server
2.
Remove all power supplies
3.
Extend or remove the server from the rack
"Extend the server from the rack" (page
4.
Remove the access panel
5.
Remove the air baffle.
122 Removal and replacement procedures
("power off the server" (page
("Access panel" (page
("PCI riser cage" (page
("power off the server" (page
("Hot-swap power supply" (page
("Remove the server from the rack" (page
99)).
("Access panel" (page
102)).
107)).
112)).
102)).
106)).
107)).
102)) or