Access Panel; Optical Drive Filler - HP Integrity rx2800 - i2 User's & Service Manual

1. Determine how many hot-swap power supplies are installed:
If only one hot-swap power supply is installed, power off and remove the power cord
from the server
If more than one hot-swap power supply is installed, continue with the next step.
2. Access the product rear panel
3. Disconnect the power cord from the power supply.
4. Remove the hot-swap power supply.
WARNING!
the power cord to the power supply until the power supply is installed.
To replace the component see

Access panel

To remove the access panel see

Optical drive filler

To remove the component:
CAUTION:
all bays are populated with either a component or a blank.
power off the server
1. Extend or remove the server from the rack.
2. Remove the access panel. See
3. Remove the fans 2 and 3. See
4. Push out the drive filler.
NOTE:
may be required to push out the drive filler.
To replace the component, reverse the procedure.
("power off the server" (page
("Access the product rear panel" (page
To reduce the risk of electric shock or damage to the equipment, do not connect
"Installing a hot-swappable power supply" (page
"Removing the access panel" (page
To prevent improper cooling and thermal damage, do not operate the server unless
("power off the server" (page
"Removing the access panel" (page
"Hot-swap fan" (page
A non conductive tool of a length of at least 20 cm and the thickness is about 1 mm
102)).
30).
102)).
30).
109).
103)).
29).
Access panel 107