PRESONUS STUDIOLIVE 24.4.2 Owner's Manual page 53

Owner's Manual
INPUTS & BUSES
INPUT CHANNELS
SUBGROUPS
AUXES 1-10
FX A / FX B
AUX IN A & B
TALKBACK
MAIN BUS
SOLO BUS
MONITOR BUS
TAPE IN
METERS
MASTER CONTROL
HIPASS NOISE GATE
OFF KEY N/A
THR .05 s
RNG N/Aj
ATK 5 ms
REL 0.7 ms
MOD EXP
ASSIGN PAN SOLO
MAINS C OFF
NULL C OFF
N/A C OFF
MAINS C
NULL C
NULL
C
The Fat Channel will be restored to the same setting for every input and
output on your StudioLive. Each of the dynamics processors and the four
bands of the EQ will be turned off. Their parameters will be set as follows:
FAT CHANNEL PARAMETERS
LIMIT COMPRESSOR
OFF THR
THR 0 dB RAT
ATK 20 ms
REL 150ms
GAIN
KNEE
Before beginning any new mixing situation, it is always recommended to recall the
Zero Out (Board Reset) scene. This is the easiest way to ensure that there are no
lingering parameter settings that could cause you some trouble in your new mix.
If you do not wish to recall a certain set of parameters, simply use
the Next and Prev buttons to navigate through the screen. When the
parameter that you wish to disable is selected, turn the Value Encoder
counter-clockwise to move it to the No (off ) position. Once you have
disabled the parameters you do not wish to recall, press the Recall button.
The StudioLive's recallable parameters are grouped as follows:
• Mute: All channel and bus mutes (Channels 1-24, Subgroups 1-4, FXA, FXB)
• FX: All parameters for the internal effects assigned to FXA and FXB
• Assigns: All output and bus routing (Mains, Subgroups, Stereo Linking,
Solo and Monitor bus assignments, and Master Control Assignments)
Scenes, Presets, and the System Menu
Creating and Recalling a Scene 5.1
SETTINGS
MUTE SELECT LINK
OFF CH1 OFF
OFF NULL OFF
NULL OFF
OFF NULL
OFF NULL
NULL
EQ LOW
0dB P/S PEAK
2:1 Q 0.6
FREQ 130Hz
GAIN 0dB
0dB
hard
To recall a Scene, press the Scene button and use
the Value encoder to scroll through the Scene
library. When you have found the Scene you wish
to recall, press the Recall button. By default, the
StudioLive will recall all of the available stored
parameters (Fat Channel settings, fader and
knob positions, channel muting and soloing,
aux mixes, and internal effects parameters).
SENDS MODE
NULL
PRE 1
BOTH SET TO F1
POST
AFL
MAIN
NULL
NULL
FX
L.MID H.MID HIGH
n/a n/a PEAK
0.6 0.6 0.6
320Hz 1.4kHz 5kHz
0dB 0dB 0dB
5
53