What You Can Process With The Fat Channel And Firewire Sends - PRESONUS STUDIOLIVE 24.4.2 Owner's Manual

Owner's Manual

4.1.2 What You Can Process with the Fat Channel and Firewire Sends.

Bus
Inputs (Ch 1-24)
Subgroups
Main Out L/R
Aux Sends 1-10
Internal FX Sends A & B
External FX Returns A & B
Tape Input
Talkback Mic
Solo Bus
Monitor Bus
A12 indicate EFX A and EFX B, and F1 and F2 indicate Aux inputs A and B.)
Selected Channel meters. In addition, two meters—part of a set of seven
meters located in the top right section of the mixer—are dedicated to
displaying information about the currently selected channel. The meter on
the far left of this section displays the pre-fader input level for the selected
channel. The meter to the right of it displays the gain reduction for the
selected channel. It is important to mention that these meters are only
active when one of the 24 input channels or an aux bus is selected.
It should be noted that while the noise gate, compressor, EQ, and
limiter are available on every input and bus, the phase reverse and
high-pass filter are only available on the 24 inputs. In addition, other
inputs and buses without Select buttons are available to route to the
auxiliary FireWire returns. (See Section 6.4.2 for more details.)
The following table provides a quick guide to the processing
that is available for each bus in the StudioLive:
Phase High-Pass Noise
Reverse Filter Gate
Compressor EQ Limiter
Controls 4
The Fat Channel 4.1
FireWire
Send
25 25