Aux Sends; Controls Overall Level Of Channel; Analog Aux Send Controls - PRESONUS STUDIOLIVE 24.4.2 Owner's Manual

4 Controls
4.4

Aux Sends

Channel Fader
Aux Sends
4.4

4.4.1 Analog Aux Send Controls

Solo Button
Post-Fader Send Button
40 40
Controls the Overall Level of the Channel.
Each input channel features a 100 mm long-throw fader for accurate
level adjustment. Unity gain (0 dB) is denoted by a "U. "
The white area above the fader can be used as a scribble strip. Use only
oil pencils; other types of pens or pencils cannot be wiped off.
To clean the scribble strip, use a lightly damp cloth to remove the writing.
The StudioLive has ten analog aux sends and two internal effects sends. The aux
sends are mono; however, two aux sends can be linked to create a stereo bus.
Section 8.5 discusses how to use these aux buses for monitor and effects mixing.
Turns Soloing On and Off.
This button will solo the aux bus to the main outputs or to the
monitor outputs, depending on whether PFL or SIP is selected in
the Solo bus section. Please review Section 8.8 for details.
When a Solo button is enabled, that channel or bus will automatically
be selected, and its Select button will illuminate.
Enables and Disables Post-Fader Send.
When this button is enabled, the send levels to that aux send will be post-
Fat Channel and post-fader, and therefore are affected by fader settings.
If the button is disabled, by default, the aux buses use the Pre 1 setting,
so that all channels on your StudioLive are sent to the aux bus after the
phase-reverse switch, high-pass filter, and noise gate but before the
compressor, EQ, limiter, and fader. However, in the System Menu, you can
select the Pre 2 setting, which makes the send occur after all Fat Channel
processing but before the fader. Please review Section 5.4 for details.
PreSonus StudioLive 24.4.2
™