System Menu - PRESONUS STUDIOLIVE 24.4.2 Owner's Manual

Hide thumbs Also See for STUDIOLIVE 24.4.2:
Table of Contents

Advertisement

Owner's Manual

System Menu

5.4
In most digital-console manuals, the phrase "System menu" inspires
a sense of dread. However, with the StudioLive, you have nothing
to fear. The System menu on the StudioLive serves just a few simple
functions, most of which have very little to do with mixing a show.
The two internal effects buses are set to Pre 2, which routes each of the 24 channels
after all Fat Channel dynamics and EQ but pre-fader. From this menu you can
choose between these two Pre positions for each Aux mix. If you have two aux
buses stereo linked, you only need to set the Pre position on the Link Master.
Remember, the Link Master is the aux that was selected when the link was created.
To find out which Aux is the Link Master, simply select either of the Aux buses in
the pair. The Link Master's ID will be shown in the Select Channel LED readout
Scene, Presets, and the System Menu
LCD Contrast and LCD Backlight.
Press the System button to access the System
menu. The first page allows you to adjust the LCD
Contrast and LCD Backlight for optimal viewing
in your working environment. These settings
are retained when the unit is powered down.
Aux Pre Position.
Press the Page Down button to access the Aux
Pre Position page. By default all ten Aux buses
are set to Pre 1. This routes all 24 channels
to each aux bus before the fader, limiter, EQ,
and compressor and after the phase-reverse
switch, high-pass filter, and noise gate.
Digital Information.
Press the Page Down button to access the
Digital Information page. From here, you can
change the Sample Rate, view your FireWire
connectivity, route a stereo mix to the S/PDIF
output, assign which StudioLive in a cascaded
chain is the Master, and merge or unmerge
the subgroups in a StudioLive chain.
5
System Menu 5.3
59

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents