Tools And Parts Required To Remove Components From An M40E Router; Packing The M40E Router For Shipment - Juniper M40E Hardware Manual

Tools and Parts Required to Remove Components from an M40e Router

Related
Documentation

Packing the M40e Router for Shipment

Copyright © 2010, Juniper Networks, Inc.
To remove components from the router or the router from a rack, you need the following
tools and parts:
2.5-mm flat-blade (–) screwdriver, for detaching alarm relay terminal block
7/16-in. (11 mm) nut driver
Blank panels to cover empty slots
Electrostatic bag or antistatic mat, for each component
Electrostatic discharge (ESD) grounding wrist strap
Flat-blade (–) screwdriver
Mechanical lift, if available
Phillips (+) screwdrivers, numbers 1 and 2
Rubber safety cap for fiber-optic interfaces or cable
Wire cutters
Contacting Customer Support on page 307
Returning a Hardware Component to Juniper Networks, Inc. on page 308
Packing the M40e Router for Shipment on page 309
Packing M40e Components for Shipment on page 310
To pack the router for shipment:
Retrieve the shipping crate and packing materials in which the router was originally
1.
shipped. If you do not have these materials, contact your Juniper Networks
representative about approved packaging materials.
Shut down power to the router by pressing the power switch for all power supplies to
2.
the off ( O ) position. On an AC-powered router, the switch for each power supply is
on the power supply faceplate. On a DC-powered router, the switches are on the
circuit breaker box.
On the console or other management device connected to the master Routing Engine,
3.
enter CLI operational mode and issue the following command to shut down the router
software. (If two Routing Engines are installed, also issue the command on the backup
Routing Engine.)
Shut down power to the router by pressing the power switch for all power supplies to
4.
the off ( ) position. On both AC and DC power supplies, the switch is located on the
O
power supply faceplate.
Appendix G: Contacting Customer Support and Returning M40e Hardware
309