Installing The M40E Router Mounting Hardware; Rack-Mounting M40E Hardware Description - Juniper M40E Hardware Manual

CHAPTER 7
Installing the M40e Router Mounting
Hardware

Rack-Mounting M40e Hardware Description

Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
Rack-Mounting M40e Hardware Description on page 77
Installing the M40e Mounting Hardware for a Four-Post Rack on page 78
Installing the M40e Mounting Hardware for an Open-Frame Rack on page 78
Install the mounting hardware before you install the router. After you install the mounting
hardware, proceed to "Installing the M40e Router Using a Mechanical Lift" on page 81
or "Installing the M40e Chassis into the Rack" on page 95, depending on your type of
installation.
The mounting hardware required and the procedure for installing the mounting hardware
depends on the type of rack.
The following mounting hardware is supplied with the M40e MultiService Edge Router:
Mounting shelf—Required for all mounting options
Front-mounting flanges on the chassis—Required for a four-post rack or cabinet, or
for front-mounting in an open-frame rack
Center-mounting brackets attached to the sides of the chassis—Required for
center-mounting in an open-frame rack
"M40e Chassis Description" on page 8 shows the center-mounting brackets and the
front-mounting flanges.
M40e Rack Size and Strength on page 69
M40e Clearance Requirements for Airflow and Hardware Maintenance on page 71
M40e Site Preparation Checklist on page 67
Installing the M40e Mounting Hardware for a Four-Post Rack on page 78
Installing the M40e Mounting Hardware for an Open-Frame Rack on page 78
77