Providing Power To The M40E Router; Connecting Ac Power To The M40E Router - Juniper M40E Hardware Manual

CHAPTER 12

Providing Power to the M40e Router

Connecting AC Power to the M40e Router

Copyright © 2010, Juniper Networks, Inc.
Connecting AC Power to the M40e Router on page 119
Connecting DC Power to the M40e Router on page 120
To connect AC power to the router:
Verify that the power supplies are fully inserted in the chassis and the thumbscrews
1.
on their faceplates are tightened.
For each power supply, verify that the ends of the power cord are firmly plugged into
2.
the appliance inlet on the power supply faceplate and the external power source
receptacle.
NOTE: The AC power source must supply 220 VAC power (nominal range
200–240 VAC), not 110 VAC power (nominal range 100–120 VAC).
Connect a management device to one of the ports on the Connector Interface Panel
3.
(CIP) ( ,
AUXILIARY CONSOLE
to become the master. For more information on connecting management devices,
see "Replacing Connections to the M40e Routing Engine Interface Ports" on page 163.
Turn on the management device.
4.
Press the power switch on the faceplate of one power supply to the
5.
Verify that the green
OUTPUT OK
, or ) for the Routing Engine that is configured
ETHERNET
LED eventually lights steadily.
( ) position.
ON |
119