The Next Step - Juniper E SERIES BROADBAND SERVICES ROUTERS 11.3.X - E120 AND E320 HARDWARE GUIDE REV 9-29-2010 Hardware Manual

E120 and E320 11.3.x Hardware Guide

The Next Step

44
A bar that you pull sideways, then outward
A tab that you pull sideways, then outward
Figure 24: Possible Release Mechanisms on the SFP
Release the SFP and pull it out of the slot.
5.
Place the SFP in an antistatic bag.
6.
When you have replaced the SFPs and connected the cables, issue the appropriate
show interface command for each interface to verify that the interface is operational
(up).
After you install the modules, you can connect cables to the system. See "Cabling the
Router" on page 45.
Copyright © 2010, Juniper Networks, Inc.