APPENDIX C
Cable Pinouts
SRP IOA
Copyright © 2010, Juniper Networks, Inc.
This appendix lists the cables and connector pinout assignments for the cables used
with the router.
SRP IOA on page 107
The SRP IOA module provides three management ports (console, auxiliary, 10/100Base-T
Ethernet). You can connect a console directly to the RS-232 serial console port or debug
auxiliary port using a shielded straight-through cable with a female DB-9 connector on
one end and a male DB-25 with a crossover adapter on the DB-25 end. These ports are
called serial ports, RS-232 ports, or console ports. These ports are considered a data
terminal equipment interface (DTE). Direct connection to a terminal or PC (which also
have DTE interfaces) requires a crossover cable.
See Figure 35 on page 107 and Table 17 on page 107 for the pinout of the console port.
See Figure 35 on page 107 and Table 18 on page 108 for the pinout of the auxiliary port.
See Table 19 on page 108 for the pinout of the Ethernet port.
Figure 35: SRP IOA Console Port and Auxiliary Port Pinout
Table 17: SRP IOA – RS-232 Console Connector Pinout
Pin
1
2
Signal
DCD
RXD
107