Adjusting Transmission Suspension - Porsche 928 Workshop Manual

928
Automatic Transmission/Controls, Case
37
a
ADJUSTING TRANSMISSION SUSPENSION
The transmission mounts have to be adjusted
to avoid tension in the transmission
suspension and to also guarantee good
insulation.
1
a 2
Install transmission and rear axle. Tighten
transmission mount/transmission case
mounting bolts with 85 Nm/61 ftlb.
Screw in cross member/transmission mount
bolts several turns.
3. Lift transmission in middle of case far
enough that there is a gap between both
transmission mounts and the cross member.
Measure this gap on both sides and take up
difference with shims.
4. Place shims of pertinent thickness between
transmission mounts and cross member,
lower transmission and tighten transmission
mounts/cross member bolts with 85 Nml
61 ftlb.
Note:
After tightening the mounting bolts there
must be at least 1 mm clearance between
the transmission case and stop on side of
transmission mount.
Printed in Germany VIII, 1984
Adjusting Transmission Suspension 37-123