Porsche 928 Workshop Manual page 22

37
Automatic Transmission/Controls, Case
928
Note:
Installing
1. Attach cable sleeve on selector lever base,
tightening the hexagon nut carefully.
2. Push cable on to selector lever pin and
install circlip.
3. Attach tailing wire, pulled forward during
removal, on cable and pull cable toward
rear, whereby one person should guide in
the selector lever base and a second person
must pull wire and cable.
4. Install selector lever base in correct
position (watching mark) and tighten
mounting screws with 15 Nm/ll ftlb.
5. Install cover frame and selector lever grip.
Place selector lever at "N".
If light opening of gate and letter "N" are
not exactly opposite each other in cover
frame, remove cover frame again and reposi-
tion selector lever base in slots.
6. Mount selector lever cable on transmission
as specified.
7. Adjust selector lever cable (see page
37 - 105).
37 - 104
Removing and Installing Selector Lever Cable
Printed in Germany