928
Differential,
Transaxle
System
39
a
Procedure
~~~~~~~~~
Execution
I Notes
- Connect ring flange (No. 3) to measuring line
(No. 2). Proceed by fitting this assembly, complete
with banjo bolt, seals and fitting (Nos. 4, 5 and 6).
to the transverse
lock slave cylinder,
replacing
the bleeder valve.
Important
note
Tighten Nos. 4 and 6 carefully and use a second
wrench to lock when tightening,
making sure the
parts do not bind. If this is not observed, the fitting
(No. 6) may shear off. Pilot pressure is normally
present at the bleeding valve (No. 6). Open valve
slowly before removing it (to allow the pressure level
to be dumped slowly)
l
PSD-Diagnosis
/ Troubleshooting
Printed in Germany - XXVII, 1991
D39 - 207