38
Automatic
Transmission/Gears,
Valve
Body
928
4. Install springs in piston and place on
diaphragm
spring, whereby
each spring
must be centered by a guide pin.
5. Apply
and tighten
Special Tool 9315.
6. Install snap ring and release special tool.
Check that snap ring fits properly,
7. Install diaphragm
spring with curved
surface on piston as shown in figure.
1 = Diaphragm
spring
8. Assemble set of plates as shown in layout
drawing and install in plate carrier.
Note:
New inner plates must be placed in ATF about
1 hour before installing.
Checking
Play (0.7 to 1.2 mm) of Clutch:
1. Push up snap ring around entire periphery
with a suitable screwdriver.
t
/
a
2. Check play "A"
with a feeler gauge blade.
a
38
174
Disassembling
and Assembling
Clutch
K 1
Printed ,n Germanv