Removing And Installing Selector Lever Cable - Porsche 928 Workshop Manual

928 Automatic Transmission/Controls, Case
37
REMOVING AND INSTALLING SELECTOR LEVER CABLE
Removing
1. Unscrew ground strap of battery on body.
2. Remove selector lever grip and take off
rubber boot.
3. Remove cover frame (see page 37 101).
4. Pull bulb holder carrier out of retaining
clips.
5. Mark location of selector lever base for
reinstallation and remove mounting screws.
6. Loosen intermediate muffler shield and
push aside as far as possible.
7. Disconnect selector lever cable on trans.
mission lever and detach cable sleeve on
brackets.
23
---
7
-:+@*> : ---,
i F ,/'
c-
8. Take off ball head, hexagon nut and
mounting parts.
9. Attach tailing wire on cable and pull out
selector lever base with cable by pulling
forward at an angle.
10. Remove cable circlip on selector lever
and detach cable sleeve on selector lever
base.
a
Printed inGermany VIII, 1984
Removing and Installing Selector
37 103
Lever Cable