Delta Electronics A10 User Manual page 288

•
Select the Edit On Macro
•
In the Macro section type in (2@INVERTER-2000) = 2
•
This will cause the Drive to turn on when the button is selected.
The screen will look like Fig. 7.6.
•
Go to the Screen drop down and at the bottom select Screen Cycle Macro
•
Type in (2@INVERTER-0200) = 3
•
Type in (2@INVERTER-0201) = 4
•
This set's up the drive to accept control from the HMI via RS485 communication.
In the Screen Cycle Macro the user must set-up the Drive to accept the commands coming from the
HMI.
The screen will look like Fig. 7.7.
Revision Apr. 30th, 2007, 2007PDD23000002
Chapter 7 Example Explanation|ScrEdit Software User Manual
Fig. 7.6
7-5