Delta Electronics A10 User Manual page 151

Chapter 3 Element Function|ScrEdit Software User Manual
Property Description of Goto Screen / Previous Page / Previous View Buttons
Foreground Color
Style
Function
Trigger
Trigger Mode
Detail
User Security Level
Goto Screen
3-14
(Please refer to Table 3.2.2 Property Description of General Buttons.)
The user can modify the element characteristic directly without re-create a new
element. The elements that their characteristics can be modified directly by using
this option are: Goto button, Previous page and Previous view buttons.
The user can use this setting to trigger the designated controller address to be ON
before or after writing the setting value. Please note that this function can only
trigger the controller address to be ON. If the controller address needs to be
triggered again, the user should set the address to be OFF manually.
This dialog box will pop up only when the button function is "Goto screen".
Close Sub- When this option is selected, it indicates that this Goto screen
Screen button is only valid in Sub-Screen. When pressing this button, the
current (active) sub screen will be closed.
User's security When this option is selected, it will force the current user's priority
level will be set to be the lowest after the button is pressed. This can prevent the
to Low Security misoperation made by the user (operator).
after changing
screen.
Use this option to set the user priority for pressing this element. Only the priority
that is equal to or higher than the current setting can use this element.
When clicking this option, the following dialog box will pop up:
In this "Open Screen" dialog box, the user can select the desired screen from left
side and the preview screen will display on the right side. After selecting the screen
and pressing OK button, HMI will record the designated screen to this Goto button
element.
Revision Apr. 30th, 2007, 2007PDD23000002