Delta Electronics A10 User Manual page 274

Control Flag for Writing Recipe
Before writing a recipe to PLC, the user should designate the recipe number (N) first (Please refer to
the section "Control Flag for Changing Recipe
set to ON). After setting, the recipe will be written to PLC. This flag needs be set to OFF and then ON if
the user wants to trigger again.
Control Flag for Changing Recipe Group Number
There are two kinds of methods for changing and calling recipe group number. One method is to use
HMI internal register, RCPG directly. RCPG is the internal system register used for designating recipe
group number. The other method is to use Recipe Control Register (RECR) (Dn+5). When the user
wants to change HMI recipe group number through control block settings, first, it needs to write recipe
group number (N) into the high byte of this control block and use this control flag to trigger, Dn+5 (Bit 3
is set to ON). After setting, RCPG will be changed to N automatically. This flag needs be set to OFF
and then ON if the user wants to trigger again.
Register for Designating Recipe Number (RBIR)
Word
0
By writing recipe group number (N) into Designated Recipe Number Register (RBIR), RCPNO value can be
changed. The user can use the control flag for changing recipe number of Recipe Control Register (RECR)
to write recipe group number (N) into Designated Recipe Number Register (RBIR) and change RCPNO
value.
System Control Flag Register (SCFR)
Bit Number
0
1
2
3
4
5
6
7
8
9
10~15
Multi-Language Setting Value
Store the designating multi-language setting value into this register and command HMI to switch to the
Revision Apr. 30th, 2007, 2007PDD23000002
Chapter 5 Control Block and Status Block|ScrEdit Software User Manual
Designate receipt number which the user wants to change
Multi-language setting value Bit 0
Multi-language setting value Bit 1
Multi-language setting value Bit 2
Multi-language setting value Bit 3
Multi-language setting value Bit 4
Multi-language setting value Bit 5
Multi-language setting value Bit 6
Multi-language setting value Bit 7
Printer flag
Printer form feed flag
Reserved
Number"). Then, trigger this control flag to ON (Bit 2 is
Function
Function
5-7