FUTABA 12Z Series Instruction Manual page 75

*Perform the settings below after using the cursor lever to
move the cursor to the item you want to set.
1. When you want to activate functions for only
selected conditions, move the cursor to the
2. Turn the data input dial to the left until
enter button.
*The mode changes to the single mode [SINGLE].
*When using common settings at each conditions, remain in
the [GROUP] mode.
*The function is activated. (ON or OFF display)
*ON/OFF switch is not set even through the function is
activated.
the switch setup screen by pushing the
direction.
(For a description of the setting method, see [Switch Setting
Method] at the back of this manual.)
*Always on when [NULL].
(For a description of the setting method, see the description
at the back of this manual.)
(For a description of the switch setting method, see the
description at the back of this manual.)
type mixing)
select the function by turning the data input
dial and push the enter button.
data input dial.
*Check the direction by actual operation.
*Master channel control can be set to simple operating
amount of sticks and VR which do not include ATV, AFR,
D/R, and mixing setting. In this case, the switch setup
screen is displayed by pushing the enter button with "H/W"
selected by function selection. Select master channel side
control.
select the function by turning the data input
dial and push the enter button.
data input dial.
*Check the direction by actual operation.
<Model Menu (Common Functions)>
(For a description of the
setting method, see the
description at the back
of this manual.)
75