FUTABA 12Z Series Instruction Manual page 54

FREQUENCY
Frequency setting
The T12Z transmitter uses a synthesizer system.
Its frequency can be changed within the range of
the frequency band of the module used.
The frequency of the R5014DPS receiver is set
from the transmitter. Use a receiver matched to the
frequency band of the transmitter.
Receiver ID code
When the R5014DPS receiver (PCM-G3
receiver) is used, the ID code located on the back
[Return Key]
Frequency switching method
For a description of the frequency switching and
ID setting methods, refer to the procedure given in
the Basic Operation section.
Modulation scheme (Modulation) change
*The modulation selection screen appears.
SURE?" appears.
*Transmission stops and a transmit or do not transmit in the
*When the mode is changed from the PCM-G3 mode to
to the wing type used, the mode cannot be changed.
54 <Functions of Linkage Menu>
of the receiver case must be entered.
*When two receivers are used with a large model, etc., enter
the 2nd receiver ID also.
Modulation mode selection
With the T12Z, 3 modulation modes (PCM-G3/
PCM1024/PPM (FM)) can be selected. Select the
modulation mode matched to the type of receiver
used.
*After changing the modulation mode, switch the modulation
mode by turning the transmitter power off and on.
PUSH
Receiver ID code input
*Input the 8-digit ID number indicated on the receiver case.
*If you make a mistake, select [BACK SPACE] with the
cursor lever and erase the incorrect digit by pressing the
enter button.
*Once the ID code is set, re-setting is unnecessary as long as
the receiver is not changed.
WARNING
waves only after verifying the frequency.
*Also change the frequency clip. Emitting radio waves with-
[Cursor Lever]
[Data Input Dial]
[Enter Button]