FUTABA 12Z Series Instruction Manual page 117

PIT to RUD mixing (Revolution mixing)
Use this mix when you want to suppress the
reaction torque generated by main rotor pitch and
speed changes at pitch operation. Adjust so that the
nose does not move in the rudder direction.
An acceleration function which temporarily
increases the correction rate at throttle stick
acceleration/deceleration operation can be set. The
mixing rate at acceleration/deceleration can be set.
setup screen shown below by pushing the enter
button.
[Return Key]
Setting method
data input dial to the left and push the
When you want to set the selected condition
<Normal condition mixing curve>
value.
position.
is raised and lowered.
*Repeat climbing and diving from hovering at a constant
rate matched to your own rhythm and adjust the pitch so
that the nose does not deflect when the throttle is raised
and lowered.
However, when a GY Series or other heading
hold gyro is used, since correction is performed
by the gyro, this mix is not used. If this function is
used when the gyro operation mode is the AVCS
mode, the neutral position will change.
(Currently selected condition name)
<Idle up condition mixing curve>
each condition used.
<Acceleration function setting>
be set.
acceleration and deceleration can be set
independently. When an operation point
<Functions of Model Menu (Helicopter Functions)>
[Cursor Lever]
[Data Input Dial]
PUSH
[Enter Button]
117