Cisco NAC3350-PROF-K9 - NAC Profiler Server Installation Manual page 93

Chapter 3 Installing the Clean Access Manager and Clean Access Server
Connect the target installation machine to the network and access the command line of the machine by
Step 1
direct console or over a serial connection, as described in
page 3-39.
Step 2 Download the latest software version supported on the target machine as follows:
Log in to the Cisco Software Download Site at http://www.cisco.com/public/sw-center/index.shtml.
a.
You will likely be required to provide your CCO credentials.
b. Navigate to Security > Endpoint Security > Cisco Network Access Control > Cisco NAC
Appliance > Cisco NAC Appliance 4.8.
c. Download the latest 4.8(x) .ISO image (e.g. nac-4.8_3-K9.iso) and burn the image as a bootable
disk to a CD-R.
Note
Insert the CD-ROM containing the Clean Access Server .ISO file into the CD-ROM drive of the target
Step 3
CAS machine.
Reboot the machine. The Cisco Clean Access Installer welcome screen appears after the machine
Step 4
restarts:
Cisco Clean Access 4.8.3 Installer (C) 2012 Cisco Systems, Inc.
- To install a Cisco Clean Access device, press the <ENTER> key.
- To install a Cisco Clean Access device over a serial console, enter serial a
t the boot prompt and press the <ENTER> key.
boot:
Step 5 At the "
Press the Enter key if your monitor and keyboard are directly connected to the CAS.
•
Type
•
over a serial connection.
If the install CD detects an existing installation of Cisco NAC Appliance, you are presented with the
Step 6
following prompt:
Checking for existing installations.
Clean Access Server 4.8.0 installation detected.
Please choose one of the following actions:
1) Install.
2) Exit.
Choose
Step 7
Next, the Cisco NAC Appliance software installer asks you to specify whether you are installing a Clean
Step 8
Access Manager or Clean Access Server. At the following prompt, enter
a Clean Access Server.
Please choose one of the following configurations:
1) CCA Manager.
2) CCA Server.
3) Exit.
OL-20326-01
Cisco recommends burning the .ISO image to a CD-R using speeds 10x or lower. Higher
speeds can result in corrupted/unbootable installation CDs.
Welcome to the Cisco Clean Access Installer!
:" prompt, type one of the following options depending on the type of connection:
boot
and press enter in the terminal emulation console if you are accessing the appliance
serial
to perform a fresh installation of the Cisco NAC Appliance software.
1
Installing the Clean Access Server
Serial Connection to the CAM and CAS,
to perform the installation for
2
Cisco NAC Appliance Hardware Installation Guide
3-23