Cisco NAC3350-PROF-K9 - NAC Profiler Server Installation Manual page 115

Chapter 3 Installing the Clean Access Manager and Clean Access Server
The Clean Access Server is shipped with a default version of the Cisco NAC Profiler Collector
component, which needs to be enabled and configured separately when integrating with the Cisco NAC
Profiler solution.
service. For complete details on the Cisco NAC Profiler solution, refer to the
Installation and Configuration Guide
To display the version of the Collector on the CAS, SSH to the CAS machine running the Collector
Note
service and type rpm -q Collector.
Table 3-5
Command
service collector start
service collector stop
service collector verify
service collector status
OL-20326-01
Table 3-5 lists CLI commands issued on the CAS for the Cisco NAC Profiler Collector
and
Cisco NAC Profiler Collector CLI Commands for CAS
Description
Starts the Collector service on the CAS.
Shuts down the Collector service on the CAS.
Displays the configured Collector Services running on the CAS
Collector Network Configuration
Collector Name
Connection Type
Listen on IP
Network IP ACL
127.0.0.1
10.10.0.211
10.10.0.210
10.10.0.212
Port Number
Encryption type
Shared secret
Displays the running status of the individual Collector modules
on the CAS, for example:
Profiler Status
o Server
o Forwarder
o NetMap
o NetTrap
o NetWatch
o NetInquiry
o NetRelay
Release Notes for Cisco NAC
= bcas1-fw
= server
= 10.40.1.10
= 31416
= AES
= profiler
Not Installed
Running
Running
Running
Running
Running
Running
Cisco NAC Appliance Hardware Installation Guide
Useful CLI Commands for the CAM/CAS
Cisco NAC Profiler
Profiler.
3-45