Access The Cam Web Console - Cisco NAC3350-PROF-K9 - NAC Profiler Server Installation Manual

Chapter 3 Installing the Clean Access Manager and Clean Access Server
Card(s) check passed
After the configuration is complete, press Enter to reboot the CAM. After rebooting, the CAM will be
Step 21
accessible from the web console.
Configuration is complete.
Changes require a REBOOT of Clean Access Manager.
Enter the following command to reboot the CAM after configuration is complete:
# reboot
The CAM initial configuration is now complete.
After restarting, test the CAM installation:
Step 22
a.
b.
c.
The CAM should now be accessible through the web console, as described in
Console, page
•
•

Access the CAM Web Console

The Clean Access Manager web administration console is the primary interface for administering the
Cisco NAC Appliance deployment. After initial configuration is complete, use the following steps to
access the CAM web console.
OL-20326-01
Ping the eth0 interface address from a command line. If working properly, the interface should
respond to the ping.
For a FIPS-compliant CAM, verify FIPS functionality as follows:
Ensure the FIPS card operation switch is set to "O" (for operational mode).
–
– Log into the CAM console interface as
– Navigate to the /perfigo/common/bin/ directory.
– Enter
./test_fips.sh info
Installed FIPS card is nCipher
Info-FIPS file exists
Info-card is in operational mode
Info-httpd worker is in FIPS mode
Info-sshd up
If the CAM does not respond, try connecting to the CAM using SSH (Secure Shell). Connect with
the username and password. Once connected, try pinging the default gateway to see if the CAM
root
can reach the external network.
If after installation you need to reset the initial configuration settings for the CAM, connect to the
CAM machine directly or through SSH and use the CLI command
Once the CAM is configured, you will be able to access the CAM web console to add product
licenses, and add initially configured Clean Access Servers to the CAM for management and further
configuration, as described in
If both tests fail, make sure that you have configured the IP address correctly and that the other
network settings are correct.
3-11.
For the commands to manually stop and start the CAM, see
For network card configuration issues, see
.
root
and verify the following output:
Access the CAM Web Console, page
Configuring Additional NIC Cards, page
Cisco NAC Appliance Hardware Installation Guide
Installing the Clean Access Manager
service perfigo config
3-11.
Access the CAM Web
CAM CLI Commands, page
3-37.
.
3-42.
3-11