Manually Restarting The Cam/Cas Configuration Utility - Cisco NAC3350-PROF-K9 - NAC Profiler Server Installation Manual

Manually Restarting the CAM/CAS Configuration Utility

Table 3-5
Command
service collector restart
service collector config
Manually Restarting the CAM/CAS Configuration Utility
If after installation you need to reset the configuration settings, or if you need to start the configuration
utility manually, you can issue the
Server or Clean Access Manager. When using
service perfigo reboot
Connect to the CAS or CAM through direct console connection, serial connection, or SSH.
Step 1
Login as
Step 2
Enter the
Step 3
Accept the default values or provide new ones for all prompts (as described in
Step 4
Configuration, page 3-6
When configuration is done, enter
Step 5
Cisco NAC Appliance Hardware Installation Guide
3-46
Cisco NAC Profiler Collector CLI Commands for CAS
service perfigo config
or
reboot
with the correct password.
root
service perfigo config
or Perform the Initial CAS Configuration, page
service perfigo reboot
Chapter 3 Installing the Clean Access Manager and Clean Access Server
Description
Stops and then restarts the Collector service on the CAS. This is
used when the service is already running and you want to restart
it.
Starts the Collector service configuration script to allow
communication with the Cisco NAC Profiler Server. For
example:
[root@caserver12 /]# service collector config
Enable the NAC Collector (y/n) [y]:
Configure NAC Collector (y/n) [y]:
Network configuration to connect to a NAC Profiler
Server
Connection type (server/client) [client]:
Connect to IP [127.0.0.1]: 192.168.96.20
Port number [31416]:
Encryption type (AES, blowfish, none) [AES]: none
Shared secret []: cisco1232
-- Configured caserver12-fw
-- Configured caserver12-nm
-- Configured caserver12-nt
-- Configured caserver12-nw
-- Configured caserver12-ni
-- Configured caserver12-nr
NAC Collector has been configured
For detailed installation and configuration information, see the
Cisco NAC Profiler Installation and Configuration
CLI command on either the Clean Access
service perfigo config
after configuration is complete to reboot the machine.
command.
or
Guide.
, you will also need to enter
Perform the Initial CAM
3-24).
to reboot the machine.
reboot
OL-20326-01