Cas Cli Commands; Cas Cli Commands For Cisco Nac Appliance - Cisco NAC3350-PROF-K9 - NAC Profiler Server Installation Manual

Chapter 3 Installing the Clean Access Manager and Clean Access Server
Restart Initial Configuration
To start the configuration script, type
example:
This command causes the configuration utility script to start (on either the CAS or CAM). The script lets
you configure the network settings for the CAM (see
for instructions). After running and completing
perfigo reboot
For details on restoring the database from automated and manual backup snapshots via command line
Note
utility, see the

CAS CLI Commands

The CAM web admin console allows you to perform most of the tasks required for administering Cisco
NAC Appliance deployment. However, there are two cases where the command line interface of the
CAS can be or must be used:
•
•
To run the CLI commands, access the CAS using SSH and log in as user
password. If already serially connected to the CAS, you can run CLI commands from the terminal
emulation console after logging in as

CAS CLI Commands for Cisco NAC Appliance

The format
lists the commonly used Cisco NAC Appliance CLI commands.
Table 3-4
Command
service perfigo start
service perfigo stop
OL-20326-01
[root@camanager root]# service perfigo config
or to reset the CAM with the modified configuration settings.
reboot
Cisco NAC Appliance - Clean Access Manager Configuration Guide, Release
Use the CAS CLI Commands for Cisco NAC Appliance
for initial configuration of the CAS or if the web admin console is unavailable due to incorrect
network or VLAN settings.
If you have purchased the Cisco NAC Profiler solution, use the
Profiler to enable the Cisco NAC Profiler Collector application on the Clean Access Server.
service perfigo <command>
Cisco NAC Appliance CLI Commands for CAS
service perfigo config
Perform the Initial CAM Configuration, page 3-6
service perfigo config
(see Connect the Clean Access Manager, page
root
is used to enter a command from the command line.
Description
Starts up the CAS. If the CAS is already running, a warning message
appears. The CAS must be stopped for this command to be used.
Shuts down the Cisco NAC Appliance service.
When the management VLAN is set, this command will cause
Note
the CAS to lose network connectivity when issued. You can
use
service perfigo maintenance
Cisco NAC Appliance Hardware Installation Guide
Useful CLI Commands for the CAM/CAS
while connected through SSH. For
, make sure to run
to access the CAS configuration directly
CAS CLI Commands for Cisco NAC
and enter the root user
root
instead.
service
4.8(3).
3-4).
Table 3-3
3-43