Table of Contents
Advertisement
Chapter 3
Installing the Clean Access Manager and Clean Access Server
Summary of Steps For New Installation
Refer to the
Note
additional deployment information for new installations.
Follow the instructions on your welcome letter to obtain a valid license file for your installation. Refer
Step 1
to the instructions in
evaluating Cisco NAC Appliance, visit
license.)
Note
Obtain a bootable CD of the latest version of the software. You can log in to Cisco Secure Software and
Step 2
download the latest 4.8(x) .ISO image.
Connect the CAS to the network and connect a monitor and keyboard to the CAS, or connect your
Step 3
workstation to the CAS via serial cable, as described in
Install the software as described in
Step 4
page
Note
Perform the initial configuration of the CAS, as described in
Step 5
page
For High Availability mode, install and initially configure each CAS first before configuring HA. Refer
Note
to
Installing a Clean Access Server High Availability Pair, page 4-17
You must use identical appliances (e.g. NAC-3350 and NAC-3350) in order to configure High
Availability (HA) pairs of Clean Access Managers (CAMs) or Clean Access Servers (CASs).
Step 6
Make sure your Clean Access Manager is installed and initially configured as described in the
NAC Appliance - Clean Access Manager Configuration Guide, Release 4.8(3).
file(s) for your Clean Access Server (s) must be installed via the Clean Access Manager web console to
complete configuration of the CAS.
Add your Clean Access Server(s) to the Clean Access Manager, as described in the
Step 7
- Clean Access Manager Configuration Guide, Release
Clean Access Servers via the CAM web console, or via the CAS direct access web console for certain
specific settings.
OL-20326-01
Cisco NAC Appliance - Clean Access Manager Configuration Guide, Release 4.8(3)
Cisco NAC Appliance Service Contract/Licensing Support
CAS licenses are generated based on the eth0 address of the CAM. Both CAM and CAS licenses
are installed via the CAM web admin console.
3-22.
If your NAC-3310 appliance does not read the software on the CD ROM drive and instead
attempts to boot from the hard disk, before proceeding you will need to change the appliance
settings to boot from CD ROM as described in
Appliance CAM/CAS, page
3-24.
http://www.cisco.com/go/license/public
Connect the Clean Access Server, page
Install the Clean Access Server (CAS) Software from CD-ROM,
Configuring Boot Settings on the Cisco NAC
3-40.
Perform the Initial CAS Configuration,
4.8(3). From this point, you can configure your
Cisco NAC Appliance Hardware Installation Guide
Installing the Clean Access Server
for details. (If you are
to obtain an evaluation
for details.
Cisco
Valid FlexLM license
Cisco NAC Appliance
for
3-22.
3-21
Hide quick links:
Advertisement
Table of Contents
