Installing The Integrated Storage Controller Card - Dell PowerEdge C1100 Hardware Owner's Manual

Figure 3-13. Removing and Installing the Integrated Storage Controller Card
1 spacer pins (3)
3 SAS cables connector

Installing the Integrated Storage Controller Card

1 Turn off the system, including any attached peripherals, and disconnect
the system from its electrical outlet.
2 Open the system. See "Opening the System" on page 53.
3 Place the three spacer pins on the system board. See Figure 3-13.
4 Install the integrated storage controller card in place. See Figure 3-13.
5 Connect the SAS data cable to the integrated storage controller card.
6 Close the system. See "Closing the System" on page 54.
7 Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
2
1
3
2 integrated storage controller card
Installing System Components
73