Figure 3-16. Removing and Installing the Non-Redundant Power Supply
1
power supply
3
bracket
Installing the Non-Redundant Power Supply
1 Insert the replacement power supply and the securing bracket firmly into
the bay. See Figure 3-16.
2 Replace the two screws at the back.
3 Replace the four screws securing the bracket.
4 Replace the cables connecting the power supply to the system board and
backplane. See Figure 5-2, Figure 5-4, and Figure 5-6.
5 Replace the system cover. See "Closing the System" on page 54.
6 Connect the power cable to the power supply and plug the cable into a
power outlet.
7 Reconnect your system and peripherals to their electrical outlets, and turn
on the system.
78
Installing System Components
1
3
2
screws (6)
2