Installing The Control Panel Assembly - Dell PowerEdge C1100 Hardware Owner's Manual

4 Slide the cover away toward the back of the system to remove it.
5 Disconnect the USB and LED signal cables and remove the two securing
screws.
6 Slide the front LED Board toward the front of the system to remove it.
Figure 3-24. Removing the Control Panel Assembly
1 screws (2)
3 LED signal cable

Installing the Control Panel Assembly

1 Slide the front LED Board toward the front of the system and secure in
place with the eight screw on the front and sides of the system cover.
2 Connect the USB and LED signal cables and secure in place with
the two screws.
3 Replace the cooling shroud. See "Installing the Cooling Shroud" on
page 55.
4 Replace the system cover. See "Closing the System" on page 54.
5 Reconnect the system and peripherals to their electrical outlets,
and turn on the system.
90
Installing System Components
4
2
4
2
1
USB cable
front LED board
3