Installing The Redundant Power Supply; Power Distribution Board; Removing The Power Distribution Board - Dell PowerEdge C1100 Hardware Owner's Manual

Dell server hardware owner's manual
Hide thumbs Also See for PowerEdge C1100:
Table of Contents

Advertisement

Installing the Redundant Power Supply

1 Verify that both power supplies are of the same type and have the
same maximum output power.
2 Slide the new power supply into the system until the power supply is fully
seated and the release latch snaps into place. See Figure 3-17.
3 Reconnect your system and peripherals to their electrical outlets, and turn
on the system.
NOTE:
When installing, hot-swapping, or hot-adding a new power supply in a
system with two power supplies, allow several seconds for the system to recognize
the power supply and determine its status. The power-supply status indicator turns
green to signify that the power supply is functioning properly. See Figure 1-4.

Power Distribution Board

CAUTION:
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came
with the product.
NOTE:
The power distribution board is available only for redundant
power supplies.

Removing the Power Distribution Board

1 Turn off the system, including any attached peripherals, and disconnect
the system from its electrical outlet.
2 Open the system. See "Opening the System" on page 53.
3 Remove the cooling shroud. See "Removing the Cooling Shroud" on
page 54.
4 Remove the power supplies from the system. "Removing the Redundant
Power Supply" on page 79.
5 Remove the expansion card riser. See "Removing the Expansion-Card
Riser" on page 66.
6 Remove all the cables from the power distribution board. See Figure 5-7.
7 Remove the four securing screws from the power distribution board.
8 Lift the power distribution board out of the system. See Figure 3-18.
80
Installing System Components
Many repairs may only be done by a certified service technician.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Poweredge cs24-ty

Table of Contents