Power Supplies; Removing The Non-Redundant Power Supply - Dell PowerEdge C1100 Hardware Owner's Manual

Power Supplies

WARNING:
To avoid injury, do not attempt to lift the system by yourself.
CAUTION:
Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came
with the product.

Removing the Non-Redundant Power Supply

WARNING:
the failed power supply from the AC power before removing it from the system.
CAUTION:
The system requires one power supply to operate the system normally.
Remove and replace only one power supply at a time.
1 Turn off the system, including any attached peripherals, and disconnect
the system from its electrical outlet.
2 Disconnect the power supply from the system.
3 Remove the cables connecting the power supply to the system board and
backplane. See Figure 5-2, Figure 5-4, and Figure 5-6.
4 Remove the two screws securing the power supply to the system.
5 Remove the four screws securing the bracket to the power module.
6 Lift the bracket and power supply out of the system. See Figure 3-16.
Whenever you need to lift the system, get others to assist you.
In order to reduce the risk of injury from electric shock, disconnect
Installing System Components
77