System Battery; Removing The System Battery - Dell PowerEdge C1100 Hardware Owner's Manual

System Battery

Removing the System Battery

CAUTION:
Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized
in your product documentation, or as directed by the online or telephone
service and support team. Damage due to servicing that is not authorized by Dell
is not covered by your warranty. Read and follow the safety instructions that
came with the product.
WARNING:
installed. Replace the battery only with the same or equivalent type recommended
by the manufacturer. See your safety information for additional information.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening the System" on page 53.
3 Remove the cooling shroud. See "Removing the Cooling Shroud" on
page 54.
4 Locate the battery socket. See "System Board Connectors" on page 111.
CAUTION:
To avoid damage to the battery connector, you must firmly support the
connector while installing or removing a battery.
5 Support the battery connector by pressing down firmly on the positive side
of the connector.
6 Press the battery toward the positive side of the connector and lift it out of
the securing tabs at the negative side of the connector.
There is a danger of a new battery exploding if it is incorrectly
Installing System Components
91