Table of Contents
Advertisement
T
The CD-ROM drive is not reading a disc.
Check that the disc is inserted in the CD tray with the
printed label side up.
Check that the disc is a data disc, not a music disc.
Try a different CD to see if the problem is limited to one
CD.
T
The CD does not eject due to a power failure or
software error.
If your system has an emergency eject hole, turn off the
system and insert the pointed end of a paper clip into the
eject hole. Press inward on the clip to open the door.
T
The CD-ROM drive plays music CDs but the sound is
not heard. However, .WAV and .MIDI sounds can be
heard when played.
Check that the cable connecting from the rear of the
CD-ROM drive to the riser board CD audio connector is in
place and secure.
Check the CD Audio volume setting.
Speaker Problems
Check the following problems to see the possible cause and
solution.
T
No sound from the speakers.
Check that the speaker power is on. Verify that all speaker
cable connections are correct and secure.
T
Speaker volume is too low.
Adjust the volume control on the speaker. If the volume is
still too low, adjust the volume through the system
software. See your Windows Multimedia online help.
Solving System Problems 6-9
Advertisement
Table of Contents
