Table of Contents
Advertisement
At the bottom of this screen, a message like the following
appears:
Press [ESC] to show POST, [F2] to enter SETUP.
Note:
performs a Power-On Self-Test (POST) to check
your hardware for any changes since the last
startup. To see the messages displayed during
POST, press
Setup Utility, press F2.
One beep indicates that the system has successfully
completed the power-on test. After about 5 seconds,
Windows starts up.
If a problem occurs, a series of beeps may sound. If this
happens repeatedly after powering on, power off the system
and turn to Chapter 6, "Solving System Problems." This
chapter provides helpful hints on obvious system problems.
Note:
indicating that system settings have changed,
run the CMOS Setup Utility (see Chapter 3,
"Configuring the System").
On systems loaded with the Windows NT
system, press
Ctrl Alt Del
The log-on box appears for entering a password.
2-4 Setting Up the System
When your system is started, it
Esc
. If you want to go into the
If the system displays a message
when prompted on-screen to do so.
®
4.0 operating
Advertisement
Table of Contents
