Table of Contents
Advertisement
Removing the system board — minitower
A – Chassis Floor
B – System Board
C – Handles
Replacing the System Board — Minitower
Use the following procedure to replace the system board.
1. Align the system board rails with the chassis rail guides
(see the following figure).
2. Use the two handles on the board to carefully slide the
system board partway into the chassis, along the rail
guides.
3. Stop sliding the board when the outside edge of the
system board aligns with the hinged edge of the chassis
floor.
D – Riser Board
E – System Board Connector
Installing Options 5-49
Advertisement
Table of Contents
