NEC POWERMATE ES 5200 Manual page 184

Use the following table when configuring IDE drives on the
primary and secondary IDE connectors on the riser board.
If installing a DVD-ROM device, substitute the DVD-ROM
for the CD-ROM in the following table.
IDE Connector Configuration
Configuration
1 device (hard drive)
2 devices (hard drive,
CD-ROM)
2 devices (hard drive, tape
backup)
2 devices (hard drive,
Zip drive)
2 devices (hard drive,
LS-120 drive)
3 devices (hard drive,
CD-ROM, Zip drive)
3 devices (hard drive,
CD-ROM, tape backup)
3 devices (hard drive,
CD-ROM, LS-120 drive)
3 devices (hard drive, hard
drive, CD-ROM)
3 devices (hard drive, hard
drive, tape backup)
3 devices (hard drive, hard
drive, Zip drive)
3 devices (hard drive,
hard drive, LS-120 drive)
Primary connector Secondary connector
Master - hard drive Master - none
Slave - none Slave - none
Master - hard drive Master - CD-ROM
Slave - none Slave - none
Master - hard drive Master - tape backup
Slave - none Slave - none
Master - hard drive Master - Zip drive
Slave - none Slave - none
Master - hard drive Master - LS-120 drive
Slave - none Slave - none
Master - hard drive Master - CD-ROM
Slave - none Slave - Zip drive
Master - hard drive Master - CD-ROM
Slave - none Slave - tape backup
Master - hard drive Master - CD-ROM
Slave - none Slave - LS-120 drive
Master - hard drive Master - CD-ROM
Slave - hard drive Slave - none
Master - hard drive Master - tape backup
Slave - hard drive Slave - none
Master - hard drive Master - Zip drive
Slave - hard drive Slave - none
Master - hard drive Master - LS-120 drive
Slave - hard drive Slave - none
Installing Options 5-69