ZyXEL Communications NWA-3160 - V3.70 Manual page 148

Chapter 8 Wireless Screen
• The adjacent access points should use different radio channels when their
coverage areas overlap.
• All access points must use the same port number to relay roaming information.
• The access points must be connected to the Ethernet and be able to get IP
addresses from a DHCP server if using dynamic IP address assignment.
To enable roaming on your NWA, click WIRELESS > Wireless. The screen
appears as shown.
Figure 81 Enabling Roaming
Select the Enable Roaming check box and click Apply.
Note: Roaming cannot be enabled in Bridge / Repeater mode.
148
NWA-3160 Series User's Guide