ZyXEL Communications NWA-3160 - V3.70 Manual page 134

Chapter 8 Wireless Screen
The following table describes the bridge labels in this screen.
Table 25 Wireless: AP + Bridge
LABEL
Operating Mode
802.11 mode
Channel Width
134
DESCRIPTIONS
Select AP + Repeater in this field.
This makes sure that only compliant WLAN devices can associate
with the NWA.
Select 802.11b Only to allow only IEEE 802.11b compliant WLAN
devices to associate with the NWA.
Select 802.11g Only to allow only IEEE 802.11g compliant WLAN
devices to associate with the NWA.
Select 802.11b/g to allow both IEEE802.11b and IEEE802.11g
compliant WLAN devices to associate with the NWA. The
transmission rate of your NWA might be reduced.
Select 802.11a to allow only IEEE 802.11a compliant WLAN devices
to associate with the NWA.
Select 802.11n/g to allow both IEEE802.11n and IEEE802.11g
compliant WLAN devices to associate with the NWA. The
transmission rate of your NWA might be reduced.
Select 802.11n/a to allow both IEEE802.11n and IEEE802.11a
compliant WLAN devices to associate with the NWA. The
transmission rate of your NWA might be reduced.
The options in this field depend on the 802.11 modes that your
device supports:
• NWA-3166 supports 802.11b/g, 802.11a, 802.11n/g and
802.11n/a.
• NWA-3160 supports 802.11b only, 802.11g only, 802.11b/g
and 802.11a.
• NWA-3163 supports 802.11b only, 802.11g only and
802.11b/g.
This field displays only when you select 802.11n/g or 802.11n/a
in the 802.11 Radio Mode field.
A standard 20MHz channel offers transfer speeds of up to 150Mbps
whereas a 40MHz channel uses two standard channels and offers
speeds of up to 300Mbps. However, not all devices support 40MHz
channels.
Select the channel bandwidth you want to use for your wireless
network.
It is recommended that you select 20/40 (20/40 MHz). This allows
the NWA to adjust the channel bandwidth depending on network
conditions.
Select 20 MHz if you want to lessen radio interference with other
wireless devices in your neighborhood.
NWA-3160 Series User's Guide