Manual Firmware Upgrade Via Tftp Server; Manual Boot Code Upgrade Using The Web Configurator; Figure 106 System Tools > Firmware > Manual Firmware Upgrade: Via Tftp Server - ZyXEL Communications G-4100 V2 User Manual

27.3.2 Manual Firmware Upgrade via TFTP Server

Use the following procedure to use TFTP to upload the firmware from a TFTP server to the
ZyXEL Device.
1 Download the latest firmware from
the file if it is zipped.
2 Run a TFTP server program and specify the location of the firmware file and the
communication mode. Refer to the documentation that comes with your TFTP server
program for instructions.
3 Access the web configurator. Refer to the section on accessing the web configurator for
instructions.
4 Click SYSTEM TOOLS >, FIRMWARE > Manual Firmware Upgrade to display the
screen as shown.
Figure 106 SYSTEM TOOLS > FIRMWARE > Manual Firmware Upgrade: via TFTP Server
5 Specify the IP address of the TFTP server in the Remote TFTP Server IP Address field.
6 Specify the name of the firmware file in the File Name field.
7 Click Apply to start the file transfer process.
8 When the file transfer is completed successfully, the following message displays and the
ZyXEL Device restarts automatically to complete the firmware upgrade process.
9 After the ZyXEL Device finishes restarting, access the web configurator again. Check the
firmware version number in the System Status screen.

27.3.3 Manual Boot Code Upgrade Using the Web Configurator

Note: You might upgrade the boot code to v1.03 only if you are upgrading to firmware
version v1.00(ZB.3)c0 or higher from a lower version. In this case, you must
upgrade the firmware BEFORE you upgrade the boot code.
Chapter 27 Configuration, Firmware and Accounting Log Maintenance
www.zyxel.com and store it in a TFTP server. Unzip
G-4100 v2 User's Guide
207