How Do I Upgrade/Backup The Zynos Firmware By Using Tftp Client Program Via Lan; How Do I Restore P-660Hw-Tx V3 Configurations By Using Tftp Client Program Via Lan; What Should I Do If I Forget The System Password; How To Use The Reset Button - ZyXEL Communications P-660HW-Tx v3 Support Notes

802.11g wireless adsl2+ 4-port gateway
Hide thumbs Also See for P-660HW-Tx v3:
Table of Contents

Advertisement

5. How do I upgrade/backup the ZyNOS firmware by using TFTP client
program via LAN?
The P-660HW-Tx v3 allows you to transfer the firmware to P-660HW-Tx v3
using TFTP program via LAN. The procedure for uploading ZyNOS via TFTP
is as follows.
a. Use the TELNET client program in your PC to login to your
P-660HW-Tx v3.
b. Enter CI command 'sys stdio 0' to disable Stdio idle timeout
c. To upgrade firmware, use TFTP client program to put firmware in file
'ras' in the Prestige. After data transfer is finished, the P-660HW-Tx v3
will program the upgraded firmware into FLASH ROM and reboot itself.
d. To backup your firmware, use the TFTP client program to get file 'ras'
from the Prestige.-
6. How do I restore P-660HW-Tx v3 configurations by using TFTP client
program via LAN?
a. Use the TELNET client program in your PC to login to your
P-660HW-Tx v3.
b. Enter CI command 'sys stdio 0' disable Stdio idle timeout
c. To backup the P-660HW-Tx v3 configurations, use TFTP client program
to get file 'rom-0' from the P-660HW-Tx v3.
d. To restore the P-660HW-Tx v3 configurations, use the TFTP client
program to put your configuration in file rom-0 in the P-660HW-Tx v3.

7. What should I do if I forget the system password?

In case you forget the system password, you can erase the current
configuration and restore factory defaults this way:
Use the RESET button on the rear panel of P-660HW-Tx v3 to reset the router.
After the router is reset, the LAN IP address will be reset to '192.168.1.1', the
common user password will be reset to 'user', the Administrator password will
be reset to „1234'.

8. How to use the Reset button?

a. Turn your P-660HW-Tx v3 on. Make sure the POWER led is on (not
blinking)
b. Press the RESET button for longer than one second and shorter than
five seconds and release it.
All contents copyright © 2008 ZyXEL Communications Corporation.
P-660HW-Tx v3 Series Support Notes
7

Advertisement

Table of Contents
loading

Table of Contents