Table 6 Advanced > Lan/Wan - ZyXEL Communications G-4100 V2 User Manual

G-4100 v2 User's Guide
The following table describes the labels in this screen.
Table 6 ADVANCED > LAN/WAN
LABEL
LAN
IP Address
Subnet Mask
WAN MAC Address
WAN Port Mode
DHCP Client
Static IP
IP Address
Subnet Mask
Gateway IP address
Primary/Secondary
DNS Server
PPPoE
Username
Password
PPP MTU Setting
TCP MSS Setting
Service Name
Connect on Demand
Keep Alive
PPTP
My IP Address
My Subnet Mask
Gateway IP address
PPTP Server IP
Address
62
DESCRIPTION
Enter the LAN IP address of the ZyXEL Device in dotted decimal notation.
The default is 192.168.1.1.
Enter the LAN subnet mask in dotted decimal notation. The default is
255.255.255.0.
Select Default to use the factory assigned MAC address.
If your ISP requires MAC address authentication, select Change to and enter
the MAC address of a computer on the LAN in the fields provided.
Select this option to set the ZyXEL Device to act as a DHCP client on the
WAN. The ZyXEL Device obtains TCP/IP information (IP address, DNS
server information, etc.) from a DHCP server. This is the default setting.
Select this option to set the ZyXEL Device to use a static (or fixed) IP address.
Enter the static IP address in dotted decimal notation.
Enter the subnet mask in dotted decimal notation.
Enter the IP address of the default gateway device. The gateway is a router or
switch on the same network segment as the ZyXEL Device. The gateway
helps forward packets to their destinations. Leave this field as 0.0.0.0 if you do
not know it.
Enter the IP addresses of the primary and/or secondary DNS servers.
Select this option to activate PPPoE support. Refer to
for more information.
Enter the user name exactly as your ISP assigned. If assigned a name in the
form user@domain where domain identifies a service name, then enter both
components exactly as given.
Enter the password associated with the user name above.
Enter the MTU (Maximum Transfer Unit) size.
Enter the MSS (Maximum Segment Size) size.
Enter the name of your PPPoE service.
Select this option when you don't want the connection up all the time and
specify an idle timeout in the Max Idle Time field. This is the default setting
with an idle timeout of 10 minutes.
Select this option when you want the Internet connection up all the time and
specify a redial period in the Redial Period field. When disconnected, the
ZyXEL Device will attempt to bring up the connection after the redial period.
Select this option to activate PPTP support. Refer to
for more information.
Enter the IP address assigned to you.
Enter the subnet mask assigned to you.
Enter the IP address of the gateway device.
Enter the IP address of your ISP's PPTP server.
Section 4.6 on page 59
Section 4.7 on page 60
Chapter 4 WAN, LAN and Server Setup