Allowing Both Outgoing And Incoming Connections; Figure 93 Ipsec Configuration Dialog Box - Nortel BayStack Instant Internet 100-S Using Manual

16 In the main Setup window, click Save and Exit.
17 Click Yes to have the changes take effect immediately (optional).
18 Click Yes to test the connection (optional).

Allowing both outgoing and incoming connections

You select this option to allow both incoming and outgoing connections to
establish a tunnel. Select this option only if security is not as much of an issue.
To allow both incoming and outgoing connections for a tunnel:
1
Start Setup, and if prompted, select a unit to configure.
2
Click Add.
3
In the Select Connection Type dialog box, click IPsec.
4
In the Select Connection Device dialog box, click BayStack II.
5 In the Select Type of Connections dialog box, click Both.
The IPsec Configuration dialog box opens

Figure 93 IPsec Configuration dialog box

6
In the Name box, enter a name for the tunnel. This name must match the one
used at the other end of the tunnel.
Using the BayStack Instant Internet Management Software Version 7.11
Chapter 6 IP security and VPN
(Figure 93).
181