Changing The Unit Configuration; Figure 123 Prompt To Restore Users And Groups - Nortel BayStack Instant Internet 100-S Using Manual

Chapter 10 Instant Internet unit configuration, support, and diagnostics

Figure 123 Prompt to restore users and groups

6
If you want to restore the user and group configurations in Admin, click Yes;
otherwise, click No.
7
In the Setup main window, click Save and Exit.

Changing the unit configuration

Before you change the Instant Internet unit's configuration, you should back up
the current configuration. If the changes you make cause problems, you can
restore the original configuration using this backup file. Refer to
restoring unit configurations" on page
To change the Instant Internet unit's configuration:
The Setup program first ensures that the unit is functioning properly, and then
displays the main Setup window.
Refer to the appropriate sections that follow for instructions on changing the
Instant Internet unit's configuration. Change the information as your ISP or as a
Nortel Networks support representative advises. After each change, click Save
and Exit. You are then asked:
Start Setup, and if prompted, select a unit to configure.
Note: If you forget your password and need to configure the unit, you
can do so by resetting the DIP switches on the back of the unit. For
details, refer to the hardware manual for your Instant Interent unit.
Using the BayStack Instant Internet Management Software Version 7.11
277.
279
"Saving and