Setting Up The Netdefend Firewall - D-Link NetDefend DFL-CP310 User Manual

Setting Up the NetDefend firewall

6. In wireless models, prepare the
a. Connect the antennas that came with your NetDefend firewall to the
ANT1 and ANT2 antenna connectors in the appliance's rear panel.
b. Bend the antennas at the hinges, so that they point upwards.
7. In models with a print server, you can connect network printers as follows:
a. Connect one end of a USB cable to a USB port at the back of the unit.
If needed, you can use the provided USB extension cord.
b. Connect the other end to a printer or a USB 2.0 hub.
Warning: Verify that the USB devices' power requirement does not exceed the
appliance's USB power supply capabilities. Failure to observe this warning may
cause damage to the appliance and void the warranty.
For information on setting up network printers, see Setting up Network Printers on
page 424.
S tting e Up the NetDefend firewall
After you have installed the NetDefend firewall, you must set it up using the steps
sh own below.
When setting up your NetDefend firewall for the first time after installation, these
steps follow each other automatically. After you have logged on and set up your
password, the Setup Wizard automatically opens and displays the dialog
configuring your Internet connection. After you have configured your Internet
connection, the Setup Wizard automatically displays the dialog boxes for
regist ering your NetDefend firewall. If desired, you can exit the Setup Wizard an
perfo rm each of these steps separately.
36
NetDefend firewall for a wireless connection:
boxes for
D-Link NetDefend firewall User Guide
d