Connecting The Dfl-1600; Setting Up Firewall To Your Network - D-Link DFL-1600 Quick Manual

Connecting the DFL-1600

3.1 Connecting Firewall to Your Network
A. First, connect the power cord to the receptor at the back panel of
the DFL-1600 and then plug the other end of the power cord to a
wall outlet or power strip. Then powered on the DFL-1600 using
the on/off switch. Now the Power LED will turn ON to indicate
proper operation.
B. 1. Powered off your Cable or DSL modem; some devices may
not have a on/off switch and will require you to unplug the power
adapter. Now, the DFL-1600 should be powered on and the
Cable / DSL modem should be turned off.
2. Cable / DSL modem
Connect an Ethernet cable to the Ethernet jack located on
the Cable / DSL modem. After the Ethernet cable is securely
connected, powered on the Cable / DSL modem by turning on
the unit or plugging in the power adapter.
3. Cable / DSL modem
Insert the other end of the Ethernet cable to one of the Ethernet
ports on the front panel of the DFL-1600. The LED light above
the Enternet port will illuminate to indicate proper connection.
If the LED light is not illuminated, please go back to step B and
repeat its instructions.
C. Insert an Ethernet cable to the LAN1 port on the front panel of
the DFL-1600 and connect it to a port on your network hub or
switch. The LED light above the Ethernet port on the DFL-1600
will illuminate to indicate proper connection
D. Connecting the computer that you will use to configure the
DFL-1600 to the network hub or switch.
(Powered Off) - DFL-1600
(Powered On) - DFL-1600
3
(Powered On)
(Powered On)
06