Configuring Ssh - D-Link NetDefend DFL-CP310 User Manual

Configuring SSH

Select this
option...
Internal Network and
VPN
IP Address Range
A NY
D isabled

Configuring SSH

NetDefend firewall users can control the unit via the command line, using the SSH
(Secure Shell) management protocol. You can enable users to do so via the
Internet, by configuring remote SSH access. You can also integrate the NetDefend
firewall with SSH-based management systems.
Note: The NetDefend firewall supports SSHv2 clients only. The SSHv1 protocol
contains security vulnerabilities and is not supported.
To configure SSH
1. Click Setup in the main menu, and click the Management tab.
The Management page appears.
2. Specify from where SSH access should be granted.
392
To allow access from...
The internal network and your VPN.
A particular range of IP addresses.
Additiona l fields appear, in which you can enter the desired IP address
range.
Any IP address.
Nowhere.
This completely disables access. This option is only available for
SNMP.
D-Link NetDefend firewall User Guide