Reconnecting To The Web-Based Manager; Using The Command Line Interface; Connecting To The Cli; Configuring The Dfl-500 To Run In Nat/Route Mode - D-Link DFL-500 User Manual

Reconnecting to the web-based manager

If you changed the IP address of the internal interface while using the setup wizard, you must reconnect to the
web-based manager using a new IP address. Browse to https:// followed by the new IP address of the internal
interface. Otherwise, you can reconnect to the web-based manager by browsing to https://192.168.1.99.
You have now completed the initial configuration of your DFL-500, and you can proceed to connect the DFL-
500 to your network using the information in

Using the command line interface

As an alternative to the setup wizard, you can configure the DFL-500 using the Command Line Interface (CLI).
To connect to the DFL-500 CLI, you require:
·
A computer with an available communications port
· A null modem cable with a 9-pin connector to connect to the DFL-500 Console connection (RS-232 serial
connector) (see Front and back view of the
· Terminal emulation software such as HyperTerminal for Windows
Note: The following procedure describes how to connect to the DFL-500 CLI using Windows HyperTerminal
software. You can use any terminal emulation program.

Connecting to the CLI

·
Connect the null modem cable to the DFL-500 Console connector and to the available communications
port on your computer.
·
Make sure the DFL-500 is powered on.
· Start HyperTerminal, enter a name for the connection, and Select OK.
· Type the communications port in the Connect using field and select OK.
·
Select the following port settings and select OK:
Bits per second 9600
Data bits
8
Parity
None
Stop bits
1
Flow control
None
·
Press Enter to connect to the DFL-500 CLI.
The following prompt appears:
D-Link login:
·
Type admin and press Enter twice.
The following prompt appears:
Type ? for a list of commands.

Configuring the DFL-500 to run in NAT/Route mode

Use the information that you gathered in
DFL-500 User Manual
Connecting to your
DFL-500)
NAT/Route mode settings
network.
to complete the following procedures.
21